/>
/> 
/> 
One length of M10 threaded bar.
two large washers with 11ml holes.
4 M10 nuts & one smaller washer with an 11ml hole.
Silicone lube or rubber grease.
- 1.JPG (42.5 KiB) Viewed 3131 times
First silicone lube the new rubbers.
- 2.JPG (33.96 KiB) Viewed 3131 times
You need to give them a bit of a push by hand but they will go into place.
Once you have them all in place like this.
- 3.JPG (52.75 KiB) Viewed 3131 times
You then pass the threaded bar through one side of the wishbone & fit one washer followed by the two nuts & then the other large washer.
- 4.JPG (55.55 KiB) Viewed 3131 times
Keep threading them on until the bar passes through the other side of the wishbone. Make sure the is about 3" sticking out of either side.
- 5.JPG (46.05 KiB) Viewed 3131 times
Tighten up both nuts so that one is to the inside left & the other to the inside right & it should look like this.
- 6.JPG (55.17 KiB) Viewed 3131 times
Now you grease or lube up the inserts & thread it over the bar.
- 7.JPG (47.92 KiB) Viewed 3131 times
Followed by the smaller washer & a nut.
- 8.JPG (39.05 KiB) Viewed 3131 times
Line up the insert with the aperture of the rubber & just tighten the nut.
- 9.JPG (53.25 KiB) Viewed 3131 times
Leave the bar in place & repeat this process on the other side.
Job done
- 10.JPG (53.18 KiB) Viewed 3131 times
